download best software – topdownloadsoftware.xyz





ARGOX OS 2140 PPLA DRIVERS FOR MAC

Page 76 Page Don’t show me this message again. Table Of Contents Recovery Driver Windows 7 Label Printer Beiyang. Serial Cabling Requirements Data cables must be of fully shielded construction and fitted with metal or metalized connector shells.

Uploader: Gugul
Date Added: 15 March 2016
File Size: 65.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20132
Price: Free* [*Free Regsitration Required]

Secure the four screws attaching the cutter. Miscellaneous Miscellaneous If the host shows “Printer Time out” 1. Secure the two screws for the base housing. Do not operate the printer and power argox os-2140 ppla in an area where they can get wet.

Remove the two screws under the base housing. Cutter Mode Cutter Mode Note: Page 30 FEED button. Thread the media argox os-2140 ppla the platen roller, then route the media through the argox os-2140 ppla of the cutter module.

Driver Windows 7 label Printer Altec. Replace with a new print head. Replacing the Thermal Print Head 1. Important notice during TPH Add the cutter baby board to J16 on the main board.

The bare core for argox os-2140 ppla ribbon must be 11 cm in length. Revise the factory default settings that stored in flash, even if turn off the power source cannot be eliminated.

Driver Argox OS-214 Plus

Pppa though the “Add Printer Wizard” is argox os-2140 ppla Microsoft, it too easily performs a number of tasks incorrectly when updating existing drivers.

Select the port of the printer and click “Next”.

Ground Shorted to Pin 1 Note: Driver Windows 7 Label Pinter Argox. Check all the data on the showing screen, if it is correct, click argox os-2140 ppla. Cutting occurs only when the software is properly set. This manual will help you get to know your new printer.

ARGOX OS PLUS USER MANUAL Pdf Download.

Insert the barrel connector of the power supply into the power jack on the back of the printer. Serial rs Interface Requirements Serial RS Interface Requirements The required cable argox os-2140 ppla have a nine-pin “D” type male connector on one end, which is plugged into the mating serial port located on the back of the printer.

After the related files have been copied to your system, click “Finish”.

The detection area, as illustrated below. Make sure the power switch is in the “O” position.

Argox OS-214 plus User Manual

Click the media hanger back into the media compartment. After driver installation is complete, click “Close”. Resetting Argox os-2140 ppla to Factory Defaults 1.

Select Install printer drivers and Click “Next” 6.

To print the manual completely, please, download it. Lift the top cover to expose the media compartment.

OsdOsOszOsdzOsplus. Table of Contents Add to my manuals Add.